Bcr 2000 running out of cc parameters
Once the bank switches have been reassigned as normal switches, they should be assigned specific settings as described below.
You can either do this by sending a special SYSX string (discussed below) or by using the Behringer editor utility and ungrouping the bank switches, then reprogramming them as discussed below. This is because they are used by the control surface plugin. Note that the BCR2000 bank switches also (the four switches labelled "encoder groups" need to be reprogrammed. This is the preset that you will always use with the control surface plugin. You will need to assign the settings as shown and then save the preset. These are shown in the appendix to these instructions. You need to configure a preset on the BCR2000 with a specific set of control assignments. Run the install.cmd batch file to register the filesģ. Unzip the binaries zip file into a folderĢ.
Bcr 2000 running out of cc parameters install#
I have not packaged this up into a full install package at this stage, but the process is relatively straightforward.ġ.
Bcr 2000 running out of cc parameters for free#
I'm sharing it for free because I think that Open Source is a great idea. Frustrated by the total lack of decent control surface plugins that would support my BCR2000, I wrote this software to make my life easier. I'm a professional software engineer (or at least, I like to think I'm professional), and a systems architect who also loves music (and Sonar). Full documentation is shown in the 'how to use it' section. This is the much-delayed version 1.0 of the full-duplex control surface. Should give anyone an idea of what it can do, anyway.īCR2000 full-duplex control surface - version 1.0 The notes are fairly brief so I will post them here, if that's acceptable. I just tried now and it seemed to download fine. I would have thought Mackie emulation mode for the BCF was a better bet for you - the BCR doesn't offer this, hence this project. This would then give you most of the functionality but you would not have control over send gain or send pan, and you would only get 8 parameters per insert and not 24. You would only have 8 rotary controls with switches, so you could assign the switches to Record Arm, same as the BCR2000, and the 8 knobs to match up with the second row of knobs on the BCR2000. It should work fine although functionality will be a bit restricted.